Electrical Discharge Machining EDM Roughness Comparator
Specifications:
- The EDM Roughness Comparator is rectangular in shape (7/8" x 5 ") and is a corrosion resistant electroformed nickel duplicate of actual electrocal discharge machined surface.
- There are nine replicated EDM surface finish specimens; - with range of 16 to 250 microinches.
- Supplied in a leatherette case with engineering data and instructions.
- Also available in metric with micrometer designations.
The Surface Roughness Scale provides an economical tool which permits roughness to be specified on the same basis as linear measurements. The surfaces presented are the result of years of research and engineering. Details covering this subject are now published in The American National Standards Institute (ANSI) specification titled: "Surface Texture, Surface Roughness, Waviness and Lay". ANSI/ASME B46.1
Surface Roughness Scale is made by a dual electroforming process wherein nickel is electrodeposited to provide an exact reproduction in intricate detail. The surfaces used in this scale are reproductions of accurately turned surfaces measured in microinches (millionths of an inch- 0.000001"). The numbers engraved alongside each surface are the average deviation from the mean surface expressed in microinches.
Easy to use:
Place the EDM Roughness Comparator Scale alongside your work piece. Slide the scale so that the rectangle with the surface roughness you want is adjacent to the piece you are examining. Compare by drawing the tip of the fingernail across each surface at right angles to the tool mark. The feel of the fingernail contact must be the same if the finishes are identical.
Individually serialized, calibrated and certified comparators are available at an additional charge. These prices are subject to change without notice.
Related References:
1. ISO 1302 DIN 4768 Comparison of Surface Roughness Values
2. Electrical Discharge Machining EDM Roughness Comparator
3. Polishing Polished Seamless Stainless Steel Pipe Tube
4. Stainless Steel Tubes Surface Roughness Review
5. Stainless Steel Bright Annealing/Annealed Tubes
6. China USA Surface Roughness Standard Comparison
7. Surface Roughness Conversion Chart of Stainless Steel Tube
8. Stainless Steel Tube Surface Finish Types
9. Cleaning of Stainless Steel Tubes
10. Post weld cleaning and finishing of stainless steels
11. Care and maintenance of stainless steel
12. British and American standards for tolerances, surface finish and testing of stainless steel
13. Surface Finish Degree Comparison Table between Rz Ra RMS
|
