ASTM A589 Standard for Seamless Welded Carbon Steel Pipe
ASTM A589 Standard Specification for Seamless and Welded Carbon Steel Water-Well Pipe covers four specific types of plain end or threaded and coupled carbon steel pipe for use in water wells. Water well pipe are classified into four types according to grads: type I, drive pipe; type II, water-well reamed and drifted pipe; type III, driven well pipe; and type IV, water-well casing pipe. The steel for both seamless and welded pipe shall be made by one of the following processes: open-hearth, electric furnace, or basic-oxygen. Tensile stength test, tension test, and hydrostatic test shall be required to conform to the requirements specified.
1.1 This specification covers four specific types of plain end or threaded and coupled carbon steel pipe for use in water wells.
1.2 Each type of water well pipe shall conform to the following methods of manufacture and grade as specified on the purchase order:
1.2.1 Type I, Drive Pipe Seamless or electric-resistance-welded, Grades A and B.
1.2.2 Type II, Water-Well Reamed and Drifted Pipe Seamless or electric-resistance-welded, Grades A and B, or furnace-butt welded.
1.2.3 Type III, Driven Well Pipe Seamless or electric-resistance-welded, Grades A and B, or furnace-butt welded.
1.2.4 Type IV, Water-Well Casing Pipe Seamless or electric-resistance-welded, Grades A and B, or furnace-butt welded.
1.3 The values stated in either inch-pound units or in SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values in each system are not exact equivalents; therefore, each system is to be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
Note 1 The dimensionless designator NPS (nominal pipe size) and DN (Nominal Diameter) have been substituted in this standard for such traditional terms as nominal diameter, size, and nominal size.
ASTM Standards
ASTM A53/A53M Specification for Pipe, Steel, Black and Hot-Dipped, Zinc-Coated, Welded and Seamless
ASTM A370 Test Methods and Definitions for Mechanical Testing of Steel Products
ASTM A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
ASTM A865 Specification for Threaded Couplings, Steel, Black or Zinc-Coated (Galvanized) Welded or Seamless, for Use in Steel Pipe Joints
API Standard
5L Specification for Line Pipe Available from American Petroleum Institute (API), 1220 L. St., NW, Washington, DC 20005.
Keywords
carbon steel pipe; seamless steel pipe; steel pipe; water well pipe; welded steel pipe;
|