Shore Durometer Test
The hardness testing of plastics is most commonly measured by the Shore (Durometer) test. This test measures the resistance of the plastic toward indentation. The scale provide an empirical hardness value that doesn't relate directly to the mechanical properties of the material being tested. Shore Hardness, using either the Shore A or Shore D scale, is the preferred method for rubbers/elastomers and is also commonly used for 'softer' plastics such as polyolefins, fluoropolymers, and vinyls. The Shore A scale is used for 'softer' rubbers while the Shore D scale is used for 'harder' rubbers.
The Shore hardness is measured with an apparatus known as a Durometer and consequently is also known as 'Durometer hardness'. The hardness value is determined by the penetration of the Durometer indenter foot into the sample. If the indenter completely penetrates the sample, a reading of 0 is obtained, and if no penetration occurs, a reading of 100 results. Because of the resilience of rubbers and plastics, the hardness reading my change over time - so the indentation time is sometimes reported along with the hardness number. The test method is identified in standard ISO 868.
The results obtained from this test are a useful measure of relative resistance to indentation of various grades of polymers. However, the Shore Durometer hardness test does not serve well as a predictor of other properties such as strength or resistance to scratches, abrasion, or wear,and should not be used alone for product design specifications.
|
