ASTM A381 MAW Steel Pipe With High-Pressure Systems
ASTM A381 Metal-Arc-Welded Steel Pipe for Use With High Pressure Transmission Systems. Covers metal-arc-welded steel pipe for use with high pressure transmission systems. The pipe is intended for fabrication of fittings and accessories for compressor or pump-station piping.
The required chemical composition for carbon steel, and the tensile properties of finished pipes are presented. Mechanical testing requirements namely transverse body tension test and transverse weld tension test shall be performed on each length of pipe from each lot of 100 lengths, and transverse guided-bend weld test cut from a length of pipe from each lot of 50 length, also hydrostatic test from each length of pipes shall be performed. A radiographic examination shall also be performed to ensure that the welding equipment is consistently producing the required quality.
This specification covers straight seam, double-submerged-arc-welded steel pipe (Note 1) suitable for high-pressure service, 16 in. (406 mm) and larger in outside diameter, with wall thickness from 5/16 to 1 1/2 in. (7.9 to 38 mm). The pipe is intended for fabrication of fittings and accessories for compressor or pump-station piping. Pipe ordered to this specification shall be suitable for bending, flanging (vastoning), corrugating, and similar operations.
A comprehensive listing of standardized pipe dimensions is contained in ANSI B36.10.
The term "double welded" is commonly used in the gas and oil transmission industry, for which this pipe is primarily intended, to indicate welding with at least two weld passes, of which one is on the outside of the pipe and one on the inside. For some sizes of the pipe covered by this specification, it becomes expedient to use manual welding, in which case the provisions of Note 3 shall be followed.
Nine classes of pipe, based on minimum yield point requirements, are covered as indicated in Table 1.
The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate.
The following hazard caveat applies to the test methods portion, Sections 9 and 10, only. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Referenced Documents
ASTM Standards
ASTM A370 Test Methods and Definitions for Mechanical Testing of Steel Products
ASTM A530/A530M Specification for General Requirements for Specialized Carbon and Alloy Steel Pipe
ASTM E30 Test Methods for Chemical Analysis of Steel, Cast Iron, Open-Hearth Iron, and Wrought Iron
ASME Boiler and Pressure Vessel Code
SectionIX Welding Qual
ANSI Standard
ANSIB36.10 Welded and Seamless Wrought Steel Pipe
|