ASTM A182 Standard for Steel Pipe Flanges Forged Fittings

ASTM A182 covers forged low alloy and stainless steel piping components for use in pressure systems. Included are flanges, fittings, valves, and similar parts to specified dimensions or to dimensional standard such as the ANSI specification.

For bars and products machined directly from bar, refer to ASTM A479/A 479M and ASTM A739 for the similar grades available in that specification.

Several grades of ferritic, martensitic, austenitic, and ferritic/austenitic duplex steel are included in this specification. Selection will depend upon design and service requirements.

Supplementary requirements are provided for use when additional testing or inspection is desired. These shall apply only when specified individually by the purchaser in the order.

This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable "M" specification designation (SI units), the material shall be furnished to inch-pound units.

The values stated in either inch-pound units or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.