ASTM A595 Norme pour les tubes en acier coniques pour utilisation structurelle

ASTM A595 Standard Specification for Steel Tubes, Low-Carbon or High-Strength Low-Alloy, Tapered for Structural Use covers three grades of seam-soudé, round, tapered steel tubes for structural use. Grades A and B are of low-acier au carbone or high-strength low-alloy steel composition and Grade C is of weather-resistance steel composition. The tube steel shall be hot-rolled aluminium-semikilled or fine-grained killed sheet or plate manufactured by one or more of the following processes: open-hearth, basic-oxygen, or electric-furnace. The tubes shall be made from trapezoidal sheet or plate that is preformed and then seam welded. They shall be brought to final size and propriétés by roll compressing cold on a hardened mandrel. A tensile test shall be done to determine the limite d'élasticité and the ultimate résistance à la traction of the tubes.

1.1 This specification covers three grades of seam-welded, round, tapered steel tubes for structural use. Grades A and B are of low-carbon steel or high-strength low-alloy steel composition and Grade C is of weather-resistant steel composition.

1.2 This tubing is produced in welded sizes in a range of diameters from 2 3/8 to 30 in. [60 to 762 mm] inclusive. Wall thicknesses range from 0.1046 to 0.375 in. [2.66 to 9.53 mm]. Tapers are subject to agreement with the manufacturer.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used indepedently of the other. Combining values from the two systems may result in non-conformance with the standard.

ASTM Standards

ASTM A370 Méthodes d'essai et définitions pour les essais mécaniques des produits en acier
ASTM A588/A588M Specification for High-Strength Low-Alloy Structural Steel, up to 50 ksi [345 MPa] Minimum Yield Point, with Atmospheric Corrosion Resistance
ASTM A606 Specification for Steel, Sheet and Strip, High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, with Improved Atmospheric Corrosion Resistance
ASTM A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
ASTM G101 Guide for Estimating the Atmospheric Résistance à la corrosion of Low-Alloy Steels

Keywords

carbon steel tube; steel tube: Carbon steel tube–specifications; Low-carbon steel plate–specifications; Structural steel (SS) tube–specifications; Tapered structural steel tube; Welded steel tube–specifications;